Move files to sbc_fw directory to make Arduino IDE shut up

config.h

@@ -1,73 +0,0 @@
-/*
- * @file config.h
- * @brief System configuration and constants
- *
- * Created: 21.09.2025
- * Author: ThePetrovich
- *
- * Copyright YKSA - Sakha Aerospace Systems, LLC.
- * See the LICENSE file for details.
- *
- * SPDX-License-Identifier: BSD-3-Clause
- */
-
-#ifndef CONFIG_H
-#define CONFIG_H
-
-// Firmware version
-#define FIRMWARE_VERSION_MAJOR 2
-#define FIRMWARE_VERSION_MINOR 03
-
-// Serial communication
-#define SERIAL_BAUD_RATE 38400
-#define SERIAL_BUFFER_CLEAR()                                                                                          \
-	do {                                                                                                           \
-		while (Serial.available()) {                                                                           \
-			Serial.read();                                                                                 \
-		}                                                                                                      \
-	} while (0)
-#define SERIAL_SEND_OK()                                                                                               \
-	do {                                                                                                           \
-		Serial.print("ok\n");                                                                                  \
-		Serial.flush();                                                                                        \
-		SERIAL_BUFFER_CLEAR();                                                                                 \
-	} while (0)
-
-// Timing constants
-#define STATUS_LED_BLINK_PERIOD 500U
-#define MAIN_LOOP_DELAY 10
-#define CPM_UPDATE_PERIOD 10000U
-
-// ADC and detector settings
-#define ADC_OVERSAMPLING_BITS 2	   // 16x oversampling -> 2 extra bits
-#define ADC_CHANNEL_16_MASK 0x7FFU // 11-bit channel mask
-#define ADC_CHANNEL_32_MASK 0x3FFU // 10-bit channel mask
-#define DETECTOR_CHANNEL_COUNT 2048
-#define DETECTOR_CHANNEL_32_COUNT 1024
-
-// Temperature sensor constants (MCP9700)
-#define TEMP_SENSOR_OFFSET_MV 500L // 500 mV at 0°C
-#define TEMP_SENSOR_SCALE_MV 10L   // 10 mV per degree
-#define ADC_VREF_MV 3000L	   // 3.0V reference
-#define ADC_RESOLUTION 4096L	   // 12-bit effective resolution
-
-// Voltage divider constants
-#define VOLTAGE_DIVIDER_RATIO 20.0f	// 200k and 10k resistors
-#define VOLTAGE_MV_PER_STEP 14.6484375f // (3.0 * 20) / 4096
-
-// EEPROM addresses for potentiometer settings
-#define EEPROM_POT_HV_ADDR 0
-#define EEPROM_POT_AMP_ADDR 1
-#define EEPROM_POT_DET_ADDR 2
-#define EEPROM_MAGIC_ADDR 3
-#define EEPROM_MAGIC_VALUE 0xA5 // Magic value to check if EEPROM is initialized
-
-// Default potentiometer values
-#define DEFAULT_POT_VALUE 127
-
-// Light sensor constants
-#define LSENSE_I2C_BASE_ADDR 0x38
-#define LSENSE_EXPECTED_ID 0xE0
-#define LSENSE_DATA_SIZE 12
-
-#endif // CONFIG_H